- Seam Cloth 5″ x 16.6′ $19.99
- Tile Subfloor 3’3″ x 32.8′ (108 sq. ft.) / 1m x 10m $71.28
- Seam Cloth 5″ x 98.6′ $83.58
- Tile Subfloor 3’3″ x 98.5′ (323 sq. ft.) / 1m x 30m $245.48
Standard USA Shipping: 3-5 days Standard Canada Shipping: 5-7 days
TCNA RATED “EXTRA HEAVY”
SUPERSEAL Tile Subfloor was extensively tested by the Tile Council of North America, and received the highest rating possible: “Extra Heavy.” This means you can rest peacefully knowing that the best product on the market protects your residential or commercial application.
NO STOPPING OR WAITING
SUPERSEAL Tile Subfloor and the tiles can be installed in a continuous non-stop installation from beginning to end.
CERAMICS CAN NOW USE MODIFIED THINSET
The unique characteristics of SUPERSEAL Tile Subfloor allows modified thinsets to be used with porcelain and ceramic tiles.
FASTER CURING TIMES
The membranes special fleece layers enhance the curing process. It increases tile adhesion by up to 5 times and the grouting can be done sooner. Even as early as the very next day.
TIME IS MONEY
The membrane’s unique surface also allows for pencil marks and chalk lines to stay permanent during the layout procedure. This is a huge advantage, especially when time is money.
SUPER STRENGTH – CRACK ISOLATION
Thousands of dimpled concrete pillars isolate the tiles from potential floor base cracks. The membrane’s unique hydrating process allows the thinset to maximize the bond within the tile floor assembly.
COMPATIBLE WITH HEAT MATS
The preferred and most common installation of heat mats is directly on the substrate; however, you can also install heat mats on top of SUPERSEAL Tile Subfloor.
Press in tile subfloor
Can I use SUPERSEAL Tile Subfloor over plank flooring or tongue and groove wood floors?
Yes, you can, providing you cover the surface with 3/8” plywood screwed and glued on 8” centres. Apply the SUPERSEAL as per instructions.
I need to install tile subfloor over an old floor that has floor joists of varying measurements on center. This being the space between the floor joists.
Please review these spacing requirements:
For use on floor Joists with the following spacing, natural stone and ceramic tiles require an additional plywood layer.
• 16″ OC with 5/8″ T&G
• 19.2″ OC with 3/4″ T&G
• 24″ OC with 3/4″ T&G and 3/8″ wood underlayment
On my wood subfloor what kind of thinset should I use?
It is recommended to use a modified thinset. A modified thinset has a latex polymer added, so that it provides better bonding and movement capabilities. It does not need be an expensive brand, just suitable to your application base on the information on the bag of thinset.
Can I use fast-set thinset with the tile subfloor?
Fast-set products are used primarily on small areas that can be managed in a manner of 10 minutes or less. It is important that your are fully prepared with the product pre-cut and the layout marked on the substrate prior to mixing the fast-set product.